ARK Documentation
  • ARK Electronics Docs
  • Embedded Computers
    • ARK Just A Jetson
      • Pinout
      • Block Diagram
      • Flashing Guide
      • 3D Model
  • Flight Controller
    • ARK FPV
      • Pinout
      • PX4 Instructions
      • ArduPilot Instructions
      • Betaflight Instructions
      • Bootloader Flashing Using DFU
      • 3D Models
    • ARKV6X
      • PX4 Instructions
      • ArduPilot Instructions
      • 3D Models
    • ARK Pixhawk Autopilot Bus Carrier
      • 3D Models and Case Files
      • Pinout
      • PX4 Instructions
    • ARK Jetson PAB Carrier
      • Getting Started
      • Block Diagram
      • Pinout
      • 3D Models and Case Files
      • Flashing Guide
      • ARK Software
        • Services
      • Autopilot Connections
      • Updating the Flight Controller Firmware
      • Micro USB Console
      • Power Cycling USB Ports
      • Mini DisplayPort
      • USB Wi-Fi Adapters
      • USB Bluetooth Adapters
    • ARK Pi6X Flow
      • Block Diagram
      • Pinout
      • 3D Models
      • Flashing Guide
        • Pi CM4 Lite with Micro SD
        • Pi CM4 with EMMC
        • After Flashing, Before Installing
        • Wi-Fi Setup
        • SSH
      • ARK Software
        • Services
      • Autopilot Connections
      • Updating the Flight Controller Firmware
    • ARK VOXL2 RTK PAB Carrier
      • Pinout
      • Connectors and Cables
      • 3D Models
      • Autopilot Connections
  • Electronic Speed Controller
    • ARK 4IN1 ESC
      • Pinout
      • Firmware
      • PWM Calibration
      • 3D Models
  • Radio
    • ARK M.2 LTE
      • OpenVPN
    • ARK Microhard DDL Carrier
      • 3D Model
  • Sensor
    • ARK Flow
      • Ardupilot Instructions
      • PX4 Instructions
      • 3D models & Case files
    • ARK Flow MR
      • Ardupilot Instructions
      • PX4 Instructions
      • 3D models & Case files
    • ARK CANnode
      • PX4 Instructions
      • 3D Models
  • GPS
    • ARK GPS
      • PX4 Instructions
      • 3D Models
    • ARK MOSAIC-X5 RTK GPS
    • ARK RTK Base
      • 3D Model
    • ARK RTK GPS
    • ARK TESEO GPS
    • ARK SAM GPS
      • PX4 Instructions
      • Ardupilot Instructions
      • Betaflight Instructions
      • 3D Model
  • Power
    • ARK PAB Power Module
      • PX4 Instructions
      • ArduPilot Instructions
      • 3D Model
    • ARK 12S PAB Power Module
      • PX4 Instructions
      • ArduPilot Instructions
      • 3D Model
  • IMU
    • ARK ADIS16507
      • PX4 Instructions
      • ArduPilot Instructions
      • 3D Model
    • ARK SCH16T
      • PX4 Instructions
      • ArduPilot Instructions
      • 3D Model
  • ROS2 & PX4
    • Mastering Precision Landing with PX4 & ROS2
    • Aruco Detectios Tutorial
    • Custom Modes Hardware Demo with PX4 & ROS2
    • Utilizing Custom Modes in PX4 with ROS2 and QGC
    • Simulated Offboard Mode
  • PX4 Log Encryption
  • Radio Integration
    • Doodle Labs Nimble Integration Guide for ARK Jetson PAB Carrier
  • Resources
    • Links
    • About
Powered by GitBook
On this page
  • Flight Controller USB Enable
  • Flight Controller Reset
  1. Flight Controller
  2. ARK VOXL2 RTK PAB Carrier

Autopilot Connections

There are two primary communication channels between the VOXL and the Flight Controller: Serial and USB.

Type
VOXL
Flight Controller

USB

USB

USB

Serial

UART13

Telem2

We recommend running MAVLink on USB and XRCE-DDS on Serial.

Flight Controller USB Enable

The flight controller USB will not start until GPIO_154_VBUS_SENSE from the VOXL is driven high. If this signal is high when the flight controller is reset, it will wait in the bootloader for 5 seconds before booting. If it is low, the flight controller will boot immediately.

Flight Controller Reset

The flight controller can be hard reset using the reset signal connected to VOXL pin GPIO_153_FMU_RST_REQ. The VOXL cannot reset the flight controller while it is armed. The reset signal is gated by the nARMED signal from the flight controller.

Previous3D ModelsNextARK 4IN1 ESC

Last updated 5 months ago