PX4 Instructions

Hardware Setup

Wiring

The ARK MAG is connected to the CAN bus using a Pixhawk standard 4 pin JST-GH cable. For more information, refer to the CAN Wiring instructions.

Multiple sensors can be connected by plugging additional sensors into the ARK MAG’s second CAN connector.

Firmware Setup

ARK MAG runs the PX4 DroneCAN Firmware. As such, it supports firmware update over the CAN bus and dynamic node allocation.

Flight Controller Setup

CAN Configuration

Set the following parameters in QGroundControl:

PreviousArdupilot InstructionsNext3D models & Case files

Last updated