ARK Documentation

ARK Electronics Docs
Flight Controllers
Electronic Speed Controllers
- ARK 4IN1 ESC
  - 3D Models
Radio
- ARK M.2 LTE
  - OpenVPN
Sensors
Power
- ARK PAB Power Module
  - 3D Model
- ARK 12S PAB Power Module
ROS2 & PX4
Resources
- Links
- About

Powered by GitBook

On this page

Pi CM4 with EMMC

PreviousPi CM4 Lite with Micro SD NextAfter Flashing, Before Installing

Last updated 1 month ago

When using Pi CM4 with EMMC, it must be flashed through the Micro-USB port on the board. Follow the steps at the link below. Short the two pin header labeled BOOT next to the Micro-USB port on boot before powering the board. Remember to remove the jumper after flashing to boot normally.

Once complete follow the steps at After Flashing, Before Installing

Compute Module hardware - Raspberry Pi DocumentationRaspberry_Pi